Are you in the construction or service industry? Do you have to safeguard sensitive data from public exposure? If so, then armored fiber optic cable installation may be for you.
You need to install an adequate amount of cable to drive your data transmission system. Fiber optic cable is reliable for transmitting information through light pulses. But there’s a lower limit to the type specification levels.
Armored fiber optic cable installations may vary depending on the industry and purpose. Could you keep reading to learn more about it?
Pre-Installation Planning and Site Preparation
Before armored fiber optic installation can begin, it is essential to have a solid plan in place. It includes understanding the project site and preparing it for fiber optic installation.
The first step is to conduct a site survey. Once the survey is complete, you can prepare the site for installation. It may involve clearing away debris, digging trenches, or erecting supports.
Though installing armored fiber optics can usually be done DIY, if you need clarification, it’s best to call some professional Optical Fiber installation services to ensure proper installation. Hiring a professional may also save you time, as they’re experts in the field.
Cable Routing and Installation
As with any network cabling or fiber optic cabling installation, the first step is determining the cable route. It is essential with armored fiber optic cable, as the added protection can make it more difficult to bend and route the cable.
Once the route is finally determined, the next step is to install the cable. You can do it depending on the specific application. The most common method is to pull the line through a pre-installed conduit, but other ways, such as direct burial or installation in the inner duct, may also be used.
After installing the cable, it is time to terminate and splice the fibers. It is usually done at a patch panel or other termination device. Armored fiber optic cable uses special connectors that work with the added protection provided by the armor.
Cable Testing and Troubleshooting
Following the installation of the cable, it’s essential to test it to ensure its functioning. To do this, open the ends of the cable and inspect the fibers for any damage.
Use a continuity tester or multimeter to check for breaks in the wires. Use a fiber optic inspection microscope to inspect the fibers for cracks or breaks.
Post-Installation Clean-Up
Following the testing of the cable, it’s essential to clean up the network cable installation area. To do this, remove any excess cable or materials that are not needed. Inspect the site for any potential hazards that could damage the line.
Apply a protective tape or wrap to the area where the cable is installed. Clean up any debris or mess created during the network cable installation process.
Install an Armored Fiber Optic Cable Today
Armored fiber optic cable installation effectively reduces disruptions in data connections and maintains secure data. This cable has proven reliable in the long run and is an investment worth making.
If you want improved, secure, and reliable data connections, install armored fiber optic cable today. Contact a professional today to discuss the right solution for your installation requirements.
Did you find this article helpful? If so, return to our blog to check out our other informative blog posts.